Ziller Electric Inc | Interactive Generac Generator Forum  

Go Back   Ziller Electric Inc | Interactive Generac Generator Forum > Generac Generator Tech Talk > Installation Talk

Installation Talk Questions/Concerns and help involving the installation of a Guardian Automatic Generator

Thread Tools Display Modes
Old December 30th, 2010   #1
Junior Member
Join Date: Nov 2010
Posts: 8
Default N1/N2/T1 terminal connections

Ok, I realize this may be a dumb question but I have never seen terminals like this and they are quite different from the 209, 210, 0, 194 and 23 terminals below that are the type I am familiar with. I see two screws in the middle of the N2/N1/T1 block but do not want to loosen the existing wires if not necessary. I also see what looks like a phillips indentation in the black plastic over where each wire goes but this does not look like any terminal connection I am familiar with. So the question is how do I add a wire to the T1 terminal? Thanks!

This is for a Generac 8kw new model 5882.

Last edited by Dormank; December 30th, 2010 at 11:44 PM..
Dormank is offline   Reply With Quote
Old December 31st, 2010   #2
Senior Member

Join Date: Nov 2007
Location: Malta NY
Posts: 959

Push down on the x .This will open the wire slot and allow you to insert the wire.
ohmslaw is offline   Reply With Quote

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -5. The time now is 05:32 AM.

Powered by vBulletin® Version 3.8.8
Copyright ©2000 - 2016, vBulletin Solutions, Inc.
Copyright 1985-2014 Ziller Electric Inc
Ziller Electric Inc is not representing Generac Power Systems Inc